Making Hardwood Floor Splines

When laying hardwood floors the need to reverse the direction of the tongue always comes up.

Making hardwood floor splines.

1 snap a straight line to mark the first course of. Spline dimensions are 42 in. A successful hardwood floor transition requires one of two different joints in order to change the direction of the planks. The easiest way to make a hardwood spline is to simply rip a thin strip from a board.

Thickness x 1 2 in. Natural wood grain finish. Width x 1 4 in. Length x 1 2 in.

Schedule your professional in home measure and estimate today. The best way to make a hardwood spline is shown in the drawings at right. Hie spline would likely split along the grain and the joint would come apart. Hardwood flooring splines are used to change direction for wood flooring that is nailed down.

Flooring installers do this by tapping a makeshift tongue called a spline or slip tongue into the grooves of the boards in the first course. But now imagine putting a lot of stress on a miter joint assembled with a thin long grain spline. Call 1 877 477 1116 or click here for more information. Many times during a hardwood flooring job you need to change directions in nailing.

Width x 42 in. While in the first room the grooves on each plank might point away from the door a transition allows that direction to change and the grooves to point the. Each individual spline is 1 4 in. 1 2 x 48 unfinished red oak spline spline or slip tongue fits into the groove of hardwood flooring so direction of nailing can be reversed.

A spline strip allows this to happen. The particular hardwood in this vid. A change in direction refers to the positioning of the tongue and groove joints between each adjacent plank. Packaged 10 per pack.